ABERDEEN #9 EMBOSSING - FACTORY OE PLATE. This is a DIRECTIONAL embossing. Please specify HEIGHT  x WIDTH.  We are able to run 36" wide continuous or by the side , direction running neck to rear on the side or as shown below DOOR to DOOR. We cannot emboss lightweight leather with this pattern. Send a large piece up for testing prior to ordering to determine suitability.

THIS PATTERN REQUIRES A HEAVY WEIGHT LEATHER WITH A SPECIFIC FINISH & TANNAGE TO BE ABLE TO EMBOSS PROPERLY. ( click here for ENLARGED VIEW )


Ford Oxford White shown with pattern running FRONT to REAR (diamonds point front to rear)


Ford Oxford White shown with pattern running DOOR to DOOR (diamonds point door to door). As found on 1984 T-BIRD "SPECIAL EDITION". We have the FACTORY inserts on hand for comparison. On leather sides - this pattern would run along the backbone to rear. UP to 36" WIDE


All leathers can be perforated. But due to the heat & pressure required for embossing, not all leathers are able to be embossed & may not retain the definition as designed. Deep embossing patterns do not work on soft hides, thin (less than 1.3mm) or with certain surface finishes.

Information contained herein is the property of PUTT GEORGI LTD & may not be reproduced or used without permission.

Copyright © PUTT GEORGI LTD. All rights reserved.
Revised: October 19, 2011

Call - 845-778-1314, fax 845-778-3968 or email us for additional information

 

 

Hit Counter